Roofing

 

Introduction

Mbond® Aluminium Composite Panel (Mbond ACP) widely used in both building exteriors and interiors, Aluminium Composite Panels are commonly used for roofing purposes as well.

Mbond® Aluminium Composite Panel (Mbond ACP) are built by inserting a soft, shock absorbent core (typically plastic) sandwiched between two layers of aluminium sheet metal. The purpose of this is to combine the shock absorbing qualities of the soft inner core while the lightweight but relatively durable outer aluminium protects it. And one its main uses is as Aluminium Composite Panel roof for buildings.

 

Product Specification

Standard Width:

1.22m

Thickness:

4mm

Standard Length:
1.22M / 2.44M / 3.05M / 3.66M / 4.27M / 4.88M / 5.49M / 6.10M / 6.71M / 7.32M

** Non-standard product (width, length, thickness, colour) are available subject to a minimum order quantity
** Thickness tolerance: subject to tolerance
** Colour only for reference, order based on sealed sample

 
 

Color Chart

MBOND®

MBS 9072
Metalic Silver

MBS 9075
Metalic Grey

MBS 9021
Dark Blue

MBS 9022
Blue

MBS 9076
Champagne Silver

MBS 9031
Jade Silver

MBS 9012
Bronze

MBS 9091
Yellow

MBS 9093
Orange

MBS 9033
Green

MBS 9032
Finland Green

MBS 9051
Black

MBS 9011
Reddish Brown

MBS 9095
Red

UNIBOND®

Uni-S 3072
Metalic Silver

Uni-S 3075
Metalic Grey

Uni-S 3012
Bronze

Uni-S 3011
Reddish Brown

Uni-S 3051
Black

 

Product Application

 
  • Roofing
  • Glazing Pergolas
  • Car Porches
  • Canopy Panel
  • Walkway
  • Overhead Bridge & etc
 

Product Advantages

 
  • Easy and Fast Installation
  • Flatness
  • Heatproof
  • Waterproof
  • Colour Uniformity
  • Light Weight
  • Flexible
  • Reduce Thermal Transfer
 

Installation Method

MBOND® Aluminium Composite Panel (Mbond ACP) is produced with a protective PE film on one or both sides which should be kept on until the panel is fastened

To install, 50mm of protective film should be peeled off from the edges of the sheet to allow clean sheet insertion into the glazing system.

The residual film should be removed immediately after the glazing is completed.

 
 

Make sure the support structure is clean and dry. Do not directly screw the sheet, only use aluminium clapping for joining. Must leave a gal of at least 50mm in between sheets for thermal expansion and contraction. A minimum slope of 5º roof pitch is recommended to allow adequate rain water run-off.

MBond® Aluminium Composite Panel can be cold-form by : -

* a/b >= 2
* Ø < 90˚
* R >= 180t
 
 

Important Guidelines

For maintenance and storage guidelines

 

Storage Method

Sheets should be kept indoor, protected from sunlight and rain fall by an appropriate opaque waterproof roof cover.

Cleaning Method

Use only neutral detergent or mild soap for cleaning. Wash by using soft cloth op sponge. Rinse off with lukewarm water (below 60˚C)

Cutting Method

Use circular saw blade for cutting MBOND® Aluminium Composite Panel.

 
 

Project Reference

 

HAVE

SOME ENQUIRIES?

We love to listen and hope to serve you better. Get in touch with us if you have any queries and we will get back to you as soon as possible.

CONTACT US